Oxford Button down Collar Shirt - Sky Blue

Wrap the measuring tape around the base of your neck where the shirt collar would sit. Place a finger between the tape and your neck for the easement required for comfort.

Place the begining of the measuring tape at the highest point of your shoulder/base of your neck and run through your torso. Stop measuring where you want the shirt to end.

Find the points whare your shoulders end and your arms begin. Place the mesuring tape at one shoulder point and run it across to the other shoulder point.

Wrap the measuring tape around the fullest part of your chest - just under your arm pits and across your shoulder blades. The fape should be level all the way around.

Wrap the measuring tape around the narrowest part of your torso - usually above your belly button and below your ribcage Make sure the tape is level all the way around.

Wrap the measuring tape around the fullest part of your hips. Make sure the tape is level all the way around.

Place the begining of the measuring tape at the end of your shoulder and where your arm starts. Run the tape down the outside of your arm past your elbow. Stop measuring where you want the cuff of the shirt to sit.

Wrap the measuring tape around your arm, ap- proximately 3 inches below the armpit.

To measure the collar, place the collar flat and measure from the outer edge of the buttonhole to the centre of the collar button.

Measure from the start of the front of the shirt near the collar. This is the highest point of the front of the shirt. Run the measuring tape all the way down to the bottom of the shirt.

Measure across the yoke, from one sleeve seam to the other.

Measure straight across the chest from one armpit to the other without stretching the shirt.

Measure the shirt across the width at the narrow- est point.

Measure the shirt across at the bottom.

Measure from the yoke sleeve seam along the upper fold of the sleeve to the edge of the cuff.

Measure straight across the sleeve, approximate- ly 3 inches down from the armpit.